HDX Replacement Parts
From Dakota Digital
391184 - Optional push button for relocating SW1 and SW2 from your HDX gauge face to an alternate location.
Mount below a dash or panel, or remove switch and install through the dash for the ultimate clean installation! Most HDX gauges have captive touch buttons in the gauge face that can be used, the 391184 is not required for operation of the HDX gauges with buttons on the face of the gauge.
* For HDX systems only cannot be used on any other series.
- Sensors
Sensors
SEN-04-5 -
Water Temperature Sender 100- 300°F
Includes 10 foot wire harness.
SEN-03-8 -
Oil Pressure Sender
Solid State 0- 100psi
Includes 10 foot wire harness.
130070: Small Block Chevy Oil Pressure Adaptor
It’s no secret that the small block Chevy doesn’t allow much space for an oil pressure sensor. For years, enthusiasts hit the hardware store in search of a few brass fittings to move the sensor up and away from the intake and distributor. This one-piece machined adapter gives you the clearance and flexibility you need in one convenient solution. The 130070 is machined in the USA with a male 1/8” NPT thread to fit your block, plus two female 1/8” NPT threads to accept the sensor of your choice. The female ports are at 45 and 90 degrees, allowing maximum flexibility for a variety of situations. A 1/8” NPT pipe-plug is included to block off the unused port.
SEN-01-5 - GM Speed Generator 16k PPM
Includes 10 foot wire harness.
May work with Chrysler/ Mopar Transmissions please check your transmission for proper fitment. GM generator requires a 7/8" Male thread to screw onto transmission housing.
SEN-01-5 With Ford/Tremec Adaptor 620006 -
Tremec/Ford Speed Generator 16k PPM.
Includes 10 foot wire harness.
May work with Chrysler/ Mopar Transmissions please check your transmission for proper fitment. Ford generator requires that the supplied mounting tab be bolted to the transmission housing.
620006 - Adaptor only for adding to an existing SEN-01-5 speed sensor.
130036 - 1/8" to 1/4" NPT Bushing.
130037 - 1/8" to 3/8" NPT Bushing.
130038 - 1/8" to 1/2" NPT Bushing.
130030 - 1/8" to 12mm x 1.5 Bushing with crush washer.
130032 - 1/8" to 16mm x 1.5 Bushing with crush washer.
Image shows 130036, 130037 and 130038 bushings.
394213 - Replacement 3ft main 8-pin display harness for use between control box and display / gauges.
394213-72 - Replacement 6ft main 8-pin display harness for use between control box and display / gauges.
394215 - Replacement 6ft HLC 6-pin clock harness for between the HDX control box and clock.
393111 - Replacement Buzzer
