VFD3 and VFD3x Second Series Replacement Parts
From Dakota Digital
VFD3 and VFD3x Second Series Plastic Control Box
391183-
VFD rocker switch assembly, replaces individual 250015 switches.
Mount below a dash or panel, or remove switch and install through the dash for the ultimate clean installation!
- Sensors
Sensors
SEN-04-5 -
Water Temperature Sender 100-300°F
Includes 10 foot wire harness.
SEN-03-8 -
Oil Pressure Sender
Solid State 0-100psi
Includes 10 foot wire harness.
130070: Small Block Chevy Oil Pressure Adaptor
It’s no secret that the small block Chevy doesn’t allow much space for an oil pressure sensor. For years, enthusiasts hit the hardware store in search of a few brass fittings to move the sensor up and away from the intake and distributor. This one-piece machined adapter gives you the clearance and flexibility you need in one convenient solution. The 130070 is machined in the USA with a male 1/8” NPT thread to fit your block, plus two female 1/8” NPT threads to accept the sensor of your choice. The female ports are at 45 and 90 degrees, allowing maximum flexibility for a variety of situations. A 1/8” NPT pipe-plug is included to block off the unused port.
SEN-01-5 -
GM Speed Generator 16k PPM
Includes 10 foot wire harness.
May work with Chrysler/ Mopar Transmissions please check your transmission for proper fitment. GM generator requires a 7/8" nut to screw onto transmission housing.
SEN-01-5 with Ford Adaptor 620006 -
Ford Speed Generator 16k PPM.
Includes 10 foot wire harness.
May work with Chrysler/ Mopar Transmissions please check your transmission for proper fitment. Ford generator requires that the supplied mounting tab be bolted to the transmission housing.
130036 1/8" to 1/4" NPT Bushing
130037 1/8" to 3/8" NPT Bushing
130038 1/8" to 1/2" NPT Bushing
130030 1/8" to 12mm x 1.5 Bushing with crush washer.
130032 1/8" to 16mm x 1.5 Bushing with crush washer.
Image shows 130036, 130037 and 130038 bushings.
250015 -
Replacement Odometer/ Trip Buttons.
System comes with 2 buttons.
394194 - 3.5mm male connector to 4-pin female connector. This adaptor is used for older VHX and VFD3 control boxes and BIM modules with the 3.5mm female connector to connect to the current revision 4 pin connector modules or older BIM modules to current revision modules and VHX and VFD3 control boxes.
*Requires the use of current BIM interconnect harness' which have 2 4-pin male connectors.
